Thread: Discussion PCB etching problem
View Single Post
Old Jan 27, 2006, 10:56 AM
jonathan8388 is offline
Find More Posts by jonathan8388
Registered User
Elmwood Park,NJ, United States
Joined Nov 2004
970 Posts
Guys, here is a piece of clean copper before ironing.
Dave, i am not sure how much my board weighs. all i know is that its thickness is 0.0064". i etched it outside in 35 F temperatures. it was submerged in boiling water, and constantly and aggresively agitated. it took a minimum of 20 minutes to etch. then again, i didnt put JUST the board in the etchant. i left about 1/2 an inch of copper around the board and etched.
jonathan8388 is offline Find More Posts by jonathan8388
Reply With Quote