Thread: Build Log Stevens Aero Edge 1.5
View Single Post
Old Jan 20, 2006, 10:33 PM
feathermerchant is offline
Find More Posts by feathermerchant
Use the 4S Luke
feathermerchant's Avatar
USA, TX, Euless
Joined Aug 2003
9,421 Posts
End of poll!

OK the votes are in and while you were voting, I compromised and cut between the lines. It's my $
I think it looks great.
It was not fitting well because the front 'lip' was puckering up in front and it was just too wide. Not following the curve of the turtle deck..
So I broke out the heat gun and with trembling hands and non-printable words at the ready, I threw a little heat on it, then a little more and finally began to hear the plastic creep against the wood so I backed off. The lip was taped down. After another session, it almost drops in place. Where the tape was pulling down on one side, the plastic deformed so I cut it short enough to cut that part out.
Anyway I think it is a success. Next to fit the tailfeathers and Killer we need to talk about color schemes. Any ideas?

Oh and the 2-7/8" Ultimate spinner is on the way.
feathermerchant is offline Find More Posts by feathermerchant
Reply With Quote