View Single Post
Old Nov 20, 2005, 04:36 PM
blackpete1 is offline
Find More Posts by blackpete1
Registered User
blackpete1's Avatar
Chirstchurch NZ
Joined Oct 2004
134 Posts
Quote:
Originally Posted by metomwhou
Just an update, the bearings from McMaster that Pat mentioned are exactly the same as what comes with the TTN. We still need to see a pic of that homemade ring from an axle spacer.
Tom
Hey Tom
Just wondering how you are getting on with your owb on your TTn? Have you got the new bearing in from McMaster yet & if so does it work ok?
Im having problems with my owb slipping now . Its quite strange what the owb is doing , i can get the owb to grab when the speed of the drill is slow but as soon as i increase the speed of the drill it will slip. Then if i loosen the glow plug a bit (to reduce compression) & slowly try to increase the speed of the drill it will eventually grab untill its grabing at the full speed of the drill. This takes about 5-10 mins. If the bike has been running then stalls or stops for whatever reason i can start it staight it away without any slipping from the owb but.... if the bike hasnt been going for awhile im back to square one, the owb is slipping again! weird.
Even though im having a few problems with my TTn & ive only have run about two tank of fuel though it i still love the bike.
Cheers
Pete.
blackpete1 is offline Find More Posts by blackpete1
Reply With Quote