View Single Post
Old Sep 06, 2005, 10:11 AM
R A
R A
Guest
n/a Posts
Re: finished biulding Raptor 50 but

Thanks Mark
Now that I have read the set up instructions properly, its quite clear that
the gyro is quite a clever little chap, and will do most of the fine turning
for me so long as the mechanics are set pretty close. i.e auto check of
reverse gyro, servo travel in both directions, and whether digital or
standard servo is being used. Plus as you said in hover or forward flight
set the trim for mode 0 or 1. Quite impressed with its set up now :-)


"Mark" <mkardelz@redshift.com> wrote in message
news:11hpp8mbeiooj63@corp.supernews.com...
> According to the instructions to make the center trim of mode 0 and mode 2
> the same, you need to switch between the two 5 times in one second
> intervals
> while maintaining slow level forward flight. To be honest, my Raptor
> 30V2heading hold
> still turns to the left after the procedure.
>
> From the instrutions:
> While hovering or in slow forward flight simply switch the gyro mode/gain
> switch on your transmitter back and forth five times between the two
> modes.
> Hold each mode for about 1 second. The right timing for this is easily
> obtained by counting the clicks of the switch out aloud to yourself as you
> do it. If the adjustment of the tail linkage is within a reasonable range
> of
> the correct setting the Quick-trim will now compensate for the residual
> trim
> error and the trim state of mode 0 should match that of mode 1. Repeat the
> Quick-trim sequence several times to allow the gyro to home in on the
> perfect trim.
>
> Good luck
> Mark
>
> "R A" <rawright(remove)@btinternet.com> wrote in message
> news:dfidda$9d6$1@nwrdmz03.dmz.ncs.ea.ibs-infra.bt.com...
>> Hello just finished putting together my new Raptor 50 v2 and took it of
>> the ground in heading hold mode of a csm 560 gyro that was fine tried
>> with out heading hold and it turned left slightly I put in right stick
>> and can hold a good hover my question is, it says on the csm instructions
>> that I should not use the radio trim with a head hold gyro is this
>> correct or am I interpreting it wrong as I know I can adjust the rod for
>> the desired trim but I find it hard to believe the radio manufactures
>> give us all these fine trims etc but then your told you cant use them
>> with a head hold gyro, or am I thick and missing something.
>>
>> Rob
>>

>
>