Re: finished biulding Raptor 50 but
Ok thanks for the advise
"Adrian Smith" <A.Smith@YourStadium.com> wrote in message
> "R A" <rawright(remove)@btinternet.com> wrote in message
>> my question is, it says on the csm instructions that I should not use the
>> radio trim with a head hold gyro is this correct or am I interpreting it
>> wrong as I know I can adjust the rod for the desired trim but I find it
>> hard to believe the radio manufactures give us all these fine trims etc
>> but then your told you cant use them with a head hold gyro, or am I thick
>> and missing something. Sorry I waffle to much Rob
>> "The OTHER Kevin in San Diego" <skiddz "AT" adelphia "DOT" net> wrote in
>> message email@example.com...
>>> On Mon, 5 Sep 2005 21:30:18 +0000 (UTC), "R A"
>>> <rawright(remove)@btinternet.com> wrote:
>>>>Hello just finished putting together my new Raptor 50 v2 and took it of
>>>>ground in heading hold mode of a csm 560 gyro that was fine tried with
>>>>heading hold and it turned left slightly I put in right stick and can
>>>>good hover my question is, it says on the csm instructions that I should
>>>>use the radio trim with a head hold gyro is this correct or am I
>>>>interpreting it wrong as I know I can adjust the rod for the desired
>>>>but I find it hard to believe the radio manufactures give us all these
>>>>trims etc but then your told you cant use them with a head hold gyro, or
>>>>I thick and missing something.
>>> OK, I got about 20 words in to that mess and ran out of patience
>>> trying to figure out WTH the question was...
> If I remember correctly the CSM gyro self centres when the radio is turned
> on. You should however make sure that the servo mid position is
> approximately correct.
> Your question was not that unintelligible but it would be polite to get
> the grammar and English correct to make it easier for people who are good
> enough to assist.
> Adrian Smith
> Superb aerial pictures of UK football stadiums.