View Single Post
Old Sep 06, 2005, 02:11 AM
R A
R A
Guest
n/a Posts
Re: finished biulding Raptor 50 but

my question is, it says on the csm instructions that I should not use the
radio trim with a head hold gyro is this correct or am I interpreting it
wrong as I know I can adjust the rod for the desired trim but I find it hard
to believe the radio manufactures give us all these fine trims etc but then
your told you cant use them with a head hold gyro, or am I thick and missing
something. Sorry I waffle to much Rob



"The OTHER Kevin in San Diego" <skiddz "AT" adelphia "DOT" net> wrote in
message newsjeph1dnfmd31gtlpvmgh1l976204r4n1e@4ax.com...
> On Mon, 5 Sep 2005 21:30:18 +0000 (UTC), "R A"
> <rawright(remove)@btinternet.com> wrote:
>
>>Hello just finished putting together my new Raptor 50 v2 and took it of
>>the
>>ground in heading hold mode of a csm 560 gyro that was fine tried with out
>>heading hold and it turned left slightly I put in right stick and can hold
>>a
>>good hover my question is, it says on the csm instructions that I should
>>not
>>use the radio trim with a head hold gyro is this correct or am I
>>interpreting it wrong as I know I can adjust the rod for the desired trim
>>but I find it hard to believe the radio manufactures give us all these
>>fine
>>trims etc but then your told you cant use them with a head hold gyro, or
>>am
>>I thick and missing something.

>
> OK, I got about 20 words in to that mess and ran out of patience
> trying to figure out WTH the question was...
>
>