View Single Post
Old Sep 06, 2005, 02:11 AM
The OTHER Kevin in San Diego
The OTHER Kevin in San Diego
Guest
n/a Posts
Re: finished biulding Raptor 50 but

On Mon, 5 Sep 2005 21:30:18 +0000 (UTC), "R A"
<rawright(remove)@btinternet.com> wrote:

>Hello just finished putting together my new Raptor 50 v2 and took it of the
>ground in heading hold mode of a csm 560 gyro that was fine tried with out
>heading hold and it turned left slightly I put in right stick and can hold a
>good hover my question is, it says on the csm instructions that I should not
>use the radio trim with a head hold gyro is this correct or am I
>interpreting it wrong as I know I can adjust the rod for the desired trim
>but I find it hard to believe the radio manufactures give us all these fine
>trims etc but then your told you cant use them with a head hold gyro, or am
>I thick and missing something.


OK, I got about 20 words in to that mess and ran out of patience
trying to figure out WTH the question was...