View Single Post
Old Sep 06, 2005, 02:11 AM
n/a Posts
finished biulding Raptor 50 but

Hello just finished putting together my new Raptor 50 v2 and took it of the
ground in heading hold mode of a csm 560 gyro that was fine tried with out
heading hold and it turned left slightly I put in right stick and can hold a
good hover my question is, it says on the csm instructions that I should not
use the radio trim with a head hold gyro is this correct or am I
interpreting it wrong as I know I can adjust the rod for the desired trim
but I find it hard to believe the radio manufactures give us all these fine
trims etc but then your told you cant use them with a head hold gyro, or am
I thick and missing something.