Thread: Discussion Working Micro BL Powered Models
View Single Post
Old Aug 25, 2005, 07:58 PM
matchlessaero is offline
Find More Posts by matchlessaero
Registered User
matchlessaero's Avatar
Tennessee/Mid-South US
Joined Mar 2002
1,534 Posts
Matchless F3AIM

Below is my F3AIM. This little bipe was designed to fly precision aerobatics indoors on micro brushless power. It flies all the precision maneuvers well including point rolls, knife edge, snap rolls, etc. While not an all out 3D'r (was not designed to be one), it has a very nice inverted and upright harrier as well as a very nice rolling harrier. I love the fact that I put landing gear on it. Taxiing a Micro plane to the edge of the flying area, taking of and immediately going into Knife Edge is a lot of fun

Specs are as follows:
Wingspan- 17"
Weight- 56grams
Construction- Depron and Carbon (finish is Krylon Shortkuts and Sharpie)
Servos- Falcon 1.7g
Receiver- JMP Servo Reciever
Battery- 3s 145mah
ESC- Selman Modified Castle Phoenix 10
Prop- GWS 5-3
Motor- Gary Jones 7g brushless (would also be great with the Uttam MightyMidget DoubleWhopper)
matchlessaero is offline Find More Posts by matchlessaero
Last edited by matchlessaero; Aug 26, 2005 at 05:46 PM.
Reply With Quote