Thread: Discussion Working Micro BL Powered Models
View Single Post
Old Aug 25, 2005, 04:51 AM
DENY is offline
Find More Posts by DENY
Toshiaki
DENY's Avatar
Japan
Joined Aug 2005
12 Posts
3D plane 42.5cm 44.5g

This airplane is 3D fly that aimed at 40 grams.
I made two motors for this airframe.
One is 4.8 grams, and another is 5.8 grams.
The output as which either coil setting is the same, and the same is put out.
The difference is whether to have used aluminum for the outer rotor can.
4.8grams motor are more delicate to use it for outdoor.
It took a picture of the video in 5.8 grams motor.
The video is here.
http://www.jopp-in.net/boss/1sr768.WMV
My 3d flight is unskilled.

Motor: DIY 5.8g, or 4.8g
Prop: 5x3 maximum propeller rotation 10440rpm at 4025 1.6A
Reciever: kraftroom micro4CH
servo: BLUE BIRD BMS303 x2 BA-TS-4.3 x1 (Lightening)
Controller: YGE4-BL
Battery:E-TECH 250mAh Li-Po single
Span: 425mm
AUW: 44.5g The airframe is made from the styrene foam.

I bought the falcon servo recently and I want to make the airframe of 40 grams or less.
DENY is offline Find More Posts by DENY
Last edited by DENY; Aug 25, 2005 at 05:31 AM.
Reply With Quote