View Single Post
Old Jul 26, 2005, 02:24 PM
THUREN is offline
Find More Posts by THUREN
blah...
THUREN's Avatar
United States, OR, Bend
Joined Jun 2005
2,932 Posts
OK.... Some very interesting, very good, info...

Test mule is my 3D plane, 4 cheap 9g servos, Nippy Black 2510/114, 2200mah 3 cell lipo with a charge to 12.6volts, brushless ESC with the red wire pulled.... What I did was high-temp epoxy one regulator to an approximately 1"x1"x.050" piece of aluminum, wire it into the battery side of the esc, and power the Rx through and amp meter.... I put a little tape on the hinges to simulate drag on the servos, and with no airflow, went crazy with the controls. I could never get the amp meter to read over 1.5 amps unless I REALLY yanked on the controls and these were only short bursts. The regulator/heat sink never got too hot to touch and keep in mind that the cut off temp is 250deg. F....

I'm pretty happy so far....
THUREN is offline Find More Posts by THUREN
Reply With Quote