View Single Post
Old Jun 26, 2005, 09:29 AM
olmod is offline
Find More Posts by olmod
Good Better Best quest.
olmod's Avatar
Australia, VIC, Langwarrin
Joined Apr 2004
10,590 Posts
EZ stick mount

Cut a peice of light gauge allum' sheet drill ,debur and then roll fold as per drawing ,place over bearing tube onto stick mount clamp and drill cross holes and fasten with favourite screws bolts whatever,the lastly add a couple of dollops of epoxy in the holes on the top and let cure. PS those plastic nuts and bolts make good fasteners to the stick in a prang they can break away and save extra damage to your motor.
olmod is offline Find More Posts by olmod
Reply With Quote