View Single Post
Old May 08, 2005, 06:09 AM
ScotY is offline
Find More Posts by ScotY
Registered User
ScotY's Avatar
Joined Feb 2001
2,818 Posts
I'm assuming a ball link on the underside of the servo arm will rub on the case? I guess that's going to depend on how long the arm is and how far it needs to travel.

Hard to tell from a pic, but a ball on the outside of the arm will make the pushrod angled quite a bit. I'm sure that would work but it's not the ideal situation, I think.

The HS-56 servos are really great but their odd dimensions, relative to most other servos, can be a challenge at times.

Anyway, if you want to retain the z-bend, you can try bending it. Keep in mind it's going to get a little shorter. If it ends up too short, maybe you could use a longer link? Again, not the ideal situation, but certainly usable for something like this.
ScotY is offline Find More Posts by ScotY
Reply With Quote