View Single Post
Old Apr 27, 2005, 12:10 AM
iter is offline
Find More Posts by iter
iPhly R/C with iPhone
iter's Avatar
Silicon Valley, Calif
Joined Jan 2005
1,729 Posts
When separating the parts, I found it helps to cut off pieces around the 3/8" wedges first to avoid damaging the wedges.

It's important to cut the bottom of these wedges smooth where break tabs used to be. If you don't, the wedges will not sit flat on rotor base-plates and there will be variations between angles of attack on different blades. You don't want that! It's better to have a little notch where the tab used to be than to have remains of the tab protrude.
iter is offline Find More Posts by iter
Reply With Quote