View Single Post
Old Apr 16, 2005, 09:40 AM
olmod is offline
Find More Posts by olmod
Good Better Best quest.
olmod's Avatar
Australia, VIC, Langwarrin
Joined Apr 2004
10,589 Posts
not practical

Quote:
Originally Posted by die fliedermaus
Try laying the wire on an aspirin and heating it with a soldering iron.
Stinky smoke but it removes the insulation!
the way i build ,i use a piece of fibre glass circuit board drlled with a hole saw and engraved with a dremel with holes for all the wires to poke through,after its glued to the bearing tube, i nip the wires off to within 1.5 mm of the circuit board then remove the enamel and flatten down and solder, see earlier post on my winding jig.
cheers.
olmod is offline Find More Posts by olmod
Reply With Quote