View Single Post
Old May 26, 2002, 06:42 PM
zaf is offline
zaf
Find More Posts by zaf
zaf
zaf's Avatar
Sydney, Australia
Joined Feb 2002
195 Posts
I have had three of these shafts, where the cut out did not line up. I had to take a little bit from the end of the shaft, so it would slide in further into the rotor hub. Also the plastic rotor hub is very weak, and when the screw is through the hub, it will usually expand the hole, causing the hub to turn freely about 45 degrees aroung the shaft, before it catches the cut out. Is there anyone making an aluminium rotor hub?

Andrew Zaf.
www.modelcopter.com
zaf is offline Find More Posts by zaf
Reply With Quote