View Single Post
Old May 26, 2002, 03:48 PM
Royal is offline
Find More Posts by Royal
Registered User
New Boston, MI 48164
Joined Mar 2002
179 Posts
They are the standard 4-40 3/4" hex head screws, any hobby shop should carry them,

ALso LiteMachines Shipped several Shafts that Had the Rotor cut-out located too far below the top of the shaft causing the shaft to bottow out before the hole can line up with the cut-out - 2 ways to fix this 1) call them and they will ship you a replacement ow 2) using a appropriate sized drill bit, remove just enough material from the inside of the rotor mounting hole to allow the shaft to slide farther inside the rotor thus allowing the cut-out to line up properly
Royal is offline Find More Posts by Royal
Reply With Quote