View Single Post
Old Apr 15, 2002, 09:16 PM
FX1SUB is offline
Find More Posts by FX1SUB
Green Member
FX1SUB's Avatar
NJ
Joined Mar 2002
788 Posts
Tryin to build my EZ-400G...Help!

Well I'm about to get started and I have a couple of questions.

1st: What glue to use? The directions say CA or epoxy...Should I just go to Home Depot and pick up some generic epoxy?

2nd: It comes with a three piece wing, when I matched up the end pieces with the center piece, they don't seem to fit flush. One side has a gap and the other will touch in the center but not on the edges. This would make it quite difficult to glue together? should I sand it down? Is this normal for an ARF?

As you can probably already tell, I have no experience building models....Amazing, I've built a telescope in a truss tube configuration that's 6 feet tall but this 27oz plane is already kicking my butt. Here's a link to the plane
http://www.nesail.com/ez400glider.htm

Thanks,

Joe
FX1SUB is offline Find More Posts by FX1SUB
Reply With Quote