View Single Post
Old Nov 07, 2004, 09:20 PM
slowflyer90 is offline
Find More Posts by slowflyer90
Registered User
Joined Sep 2004
40 Posts
Hi,
Thanks for the advise on the fets; I was unaware that the Pfets cost more. Saving money is always nice $-). I'll try and find the thread and check it out.

About the motor:
I finished winding it (22 turns) and it is now assembled on my kitchen table. I'll wire it with the wye connection, since it gives more torque and takes less amps. The motor will be mounted to the plane with a long brass tube attached to the back of the stator. I'm planning on cutting out a plywood disk that will fit around the brass tube to glue the Hall sensors onto.
slowflyer90 is offline Find More Posts by slowflyer90
Reply With Quote