View Single Post
Old Mar 31, 2014, 03:32 PM
pilottube is offline
Find More Posts by pilottube
I ain't afraid of no highs
pilottube's Avatar
Spain
Joined Jun 2008
466 Posts
I got my v2.4 today, very easy to install on my turnigy 9x, I installed the drivers and then I connected the USB cable, it worked..
UNTIL I touched the mini USB on the transmiter (I was tring to acomodate it in the case) and i think I shorted something with my fingers because I heard a bit like electricity on the speakers and at the same time windows gives me an error about device disconected and stops recognizing the hardware.
I keep trying connecting the transmiter in 3 diferent computers and using 4 or 5 different USB cables, but windows doesnt show even a message about new hardware found, as it did the first time... maybe I burned the board or the miniUSB port? I'd apreciate any help!

EDIT:
ok, the board is fine! It was just that I damaged the cables on the back of the microusb and they were not making proper contact.
And I just flashed openTx
:-)
pilottube is offline Find More Posts by pilottube
Last edited by pilottube; Apr 01, 2014 at 05:01 PM.
Reply With Quote