View Single Post
Old Mar 10, 2014, 01:00 PM
Otto Dieffenbach is offline
Find More Posts by Otto Dieffenbach
United States, CA, San Diego
Joined Aug 2011
2,888 Posts
Motor Mounting

Motor mounts are built with a 5mm ply center sandwiched between 1/16 ply squares. A slot is cut in the 1/4" ply for the carbon square tube. I rough up the tube with sandpaper and use slow cure epoxy to make the mounts.

The mount should be built so the motor shafts are 18.25 inches apart. the motor set will be zero/zero to the top/arm plate.
Otto Dieffenbach is offline Find More Posts by Otto Dieffenbach
Reply With Quote