: Build Log
Flyguy62 Version 3: Fully Aerobatic
View Single Post
Mar 10, 2014
, 12:52 PM
United States, CA, San Diego
Joined Aug 2011
Overview of Flyguy62 Version 3
Version 3 has the same sides as Version 1 and 2. You can keep the original head or opt for a foam mannequin head. The top/arm plate runs the length of Version 3. Version 3 is built upside down on the top/arm plate. The sides are split along the top plate line. Read the captions of the photos to understand additional details and dimensions.
View all Images in thread
Parkzone T-28/F-4u wheels and bottom plate. Bottom plate 12 inches wide and 15 inches log at the side.
Looking from the legs forward. Distance between top plate and chest plate is 6 inches.
Hinged left leg. Distance from hinge line and tip is 18 inches.
Thigh. Note original Flyguy outer body glued to the center plate and outline of thigh changed to increase side to side length to 16 inches.
Overall back. Note Depron doubler at butt and location of carbon square tube motor support.
Flyguy side shape is unchanged from Version 1 or 2. Note the line of the top/arm plate down the side. Chest plate is 6 inches below top/arm plate.
Twin motors, carbon tube support, ESC wires and mannequin head.