Thread: Discussion Flyguy
View Single Post
Old Jan 26, 2014, 10:57 AM
Otto Dieffenbach is offline
Find More Posts by Otto Dieffenbach
United States, CA, San Diego
Joined Aug 2011
2,888 Posts
Quote:
Originally Posted by ttersu View Post
Otto, will you share this FlyGuy plans? He is quite different from other ones...
No problem. I am still working on him and learning. Basically, he is a standard V1 Flyguy62 widened 7 inches. The top plate and center plate are integrated into one top plate that runs the length. The breast plate is 13.5 x 7 inches. The feet are similar to Skyman's.

I started with 7 inch props but cut them down to 6 inches because I had too much thrust. Prop diameter controls all the measurements. I'd probably make him a couple inches thinner if I was starting again.

I am happy to provide all I know to this point but I feel there is still a lot to learn.

Do you think a separate thread should be started?
Otto Dieffenbach is offline Find More Posts by Otto Dieffenbach
Reply With Quote