View Single Post
Old Nov 27, 2013, 07:28 AM
s_mack is offline
Find More Posts by s_mack
Registered Loser
Canada, BC, Central Okanagan H
Joined Jun 2010
3,369 Posts
[assuming you have the Rev 2.4] If you look closely between the two right-most 6-pin white connectors, I'd bet you would see evidence of burning.

Those two connectors are basically a "mirror" of each other. So the "outside" pins are connected together, then the next ones, and so on. To put it another way, if you assume they are numbered 1 through 6 from left to right, then its like this:

pin 1 on the left connector connects to pin 6 on the right
pin 2 to pin 5
pin 3 to pin 4
pin 4 to pin 3
....
pin 6 to pin 1

Using a multimeter, you can figure out which pair is broken and solder a small wire to re-connect them. Its probably 2/5.

- Steven

ps. You can thank the SP board for the fact your "radio still works without it though". That burned trace acted as a fuse, protecting your main board from certain (but repairable) death.
s_mack is offline Find More Posts by s_mack
Reply With Quote