Thread: Build Log RC Broom Flyer Wizard Witch
View Single Post
Old Sep 25, 2013, 04:06 PM
Otto Dieffenbach is offline
Find More Posts by Otto Dieffenbach
United States, CA, San Diego
Joined Aug 2011
2,888 Posts
Step 7

Attaching the motor supports and creating your mount.

From a sheet of 1/4 inch ply cut the lateral/horizontal motor support,10.5 x 1.375 inches. Also, cut the vertical motor support bracket to the drawing you made on the body side. Cut two motor mount plates, 1.75 x 1.75 inches, and laminate together with epoxy.

Glue the lateral/horizontal motor support to the rear of the front center body plate, as shown. With epoxy, glue the vertical motor support bracket in the center of the lateral/horizontal motor support, as shown.
Otto Dieffenbach is offline Find More Posts by Otto Dieffenbach
Last edited by Otto Dieffenbach; Sep 26, 2013 at 12:17 PM.
Reply With Quote