Thread: Build Log RC Broom Flyer Wizard Witch
View Single Post
Old Sep 25, 2013, 03:57 PM
Otto Dieffenbach is offline
Find More Posts by Otto Dieffenbach
United States, CA, San Diego
Joined Aug 2011
2,884 Posts
Step 1

Getting everything you need and prepare the cutouts.

If you get your cutouts from Hooiser Cutout Service, separate them form their sheets, identify each part and lightly sand the edges with 150 grit sandpaper. Save the extra material.

Bill of materials:

Broom Flyer cutouts in 6 mm Depron
Two 0.196" OD x 0.125" ID x 40" Carbon Fiber square tubes (Midwest Products)
One 0.125" OD x 0.060" ID x 40" Carbon Fiber tube (Midwest Products)
One .034" x .121" x 40" Carbon Fiber strip (Midwest Products)
1/8 inch plywood sheet 1 ft x 2 ft
inch plywood sheet 6 x 12 inches
8 Sheet metal screws 8 x
E-Flite Sea Fury retract landing gear (Optional)
Master Air Screw 3 blade 10 x 7 propeller
Two packages of Dubro micro pushrods #852
One bag of 15 Dubro Hinges #117
Two 1 7/8 inch wheels (Parkzone T-28 or F4u)
Clear Gorilla Glue
Foam safe CA and activator
5 minute epoxy
30 minute epoxy
Paint

Electronics:

At least a 3 channel full range receiver
Three Hitec HS 225MG servos or equivalent
E-Flite Power 10 motor or equivalent
40 Amp ESC
3S 2200mah 30C Lipo battery
4 feet of servo hook-up wire
Otto Dieffenbach is offline Find More Posts by Otto Dieffenbach
Last edited by Otto Dieffenbach; Sep 26, 2013 at 11:14 AM.
Reply With Quote