View Single Post
Old Sep 01, 2004, 06:12 AM
Mr DIY is offline
Find More Posts by Mr DIY
Registered User
Mr DIY's Avatar
South Africa
Joined Aug 2003
587 Posts
olmod ... thanx If I can get acid, I will give it a try.


Did not know that was your drawing. Certainly a great idea though. I might do something similar. Hell why not.

Is it possible to provide details of how the coils are positioned. For example, show a delta schematic with your numbers against each winding so somebody could make sense of everything by just looking at the hookups you listed? I found your table listing of the phases confusing. It may be just me though, although I doubt it.

As for running a Star hookup incorrectly, I did struggled to start my motor, but once running, it runs without problem. It depends very much on the controller as well though. I have averaging routines built into my software that would have averaged out the inconsistant BEMF signal and still run the motor with too much fuss.
Mr DIY is offline Find More Posts by Mr DIY
Reply With Quote