View Single Post
Old Aug 22, 2004, 06:36 AM
Graham Stabler is offline
Find More Posts by Graham Stabler
Sticky Shepherd
Graham Stabler's Avatar
Oxford/England
Joined May 2001
4,017 Posts
Nice, we have a Wabco in my department. Unfortunately it was CNCed by wabco. It uses stepper motors with step and direction which would be fine if each axis had it's own direction pin :O

I have all the parts collected for a serious CNC router now, THK bearings, ballscrews etc. Seriously considering servos and geckodrives but will check out JRKERR more carefully.

Graham

sorry this is off topic really
Graham Stabler is offline Find More Posts by Graham Stabler
Reply With Quote