Thread: Build Log Full Carbon Molded DeX Quad
View Single Post
Old Jun 25, 2013, 05:41 PM
DeXX is offline
Find More Posts by DeXX
DeXX's Avatar
Croatia
Joined Nov 2009
521 Posts
now I need to merge motor holders and tubes

I don't like to glue them together because later is a big problem to clean the glue if you need to replace the tube...

so I'll use the tape....

I wanted to use transparent tape...
but the adhesive on that tape was very weak




so I took a plain brown packing tape which has good adhesive for this purpose



I have put so much tape that tube barely fits on...
and again some permanently elastic kit so that water definitely does not enter




I have pressed the tube on the motor holder with all my weight and there is no way to remove the tube after that unless I split it on the side with a scalpel...
also I have used a soft wood for back support the tube because on a hard surface tube can be damaged on the edge

excess of elastic kit will come out at the junction of motor holder and the tube

DeXX is offline Find More Posts by DeXX
RCG Plus Member
Latest blog entry: FPV Bullseye
Reply With Quote