View Single Post
Old Jun 08, 2013, 12:53 PM
Hasi is offline
Find More Posts by Hasi
Registered User
Hasi's Avatar
Austria, Stmk., Graz
Joined Sep 2011
596 Posts
Quote:
Originally Posted by drpiyush View Post
I crashed and lost the tri frame and a prop day before yesterday in a wind, I have to wait until new props come from HK.

I changed the plan to xcopter, installed FW V4.7, FW update was sucessful.
Installed FCB on a custom made MDF frame withTurnigy Multistar 30 Amp Multi-rotor Brushless ESC 2-4S , Turnigy 2217 16turn 1050kv 23A Outrunner, ZIPPY Compact 1000mAh 3S 35C Lipo Pack battery and Fly sky 6ch. tx-rx.
The problem started when I tried throtle (offcourse w/o props), motor #4 starts too late, actually after 70% thorttle and cuts just below 50% throttle. I swapped motors to confirm motor+ESC at postion 4 are not malfunctioning. I also checked throttle range- its working normally if check withiout FCB.

What is the cause and solution of the problem?
Isn't #4 the servo?
Hasi is offline Find More Posts by Hasi
Reply With Quote