View Single Post
Old Jun 08, 2013, 09:23 AM
drpiyush is online now
Find More Posts by drpiyush
Registered User
India, GJ, Bhavnagar
Joined Jun 2009
138 Posts
I crashed and lost the tri frame and a prop day before yesterday in a wind, I have to wait until new props come from HK.

I changed the plan to xcopter, installed FW V4.7, FW update was sucessful.
Installed FCB on a custom made MDF frame withTurnigy Multistar 30 Amp Multi-rotor Brushless ESC 2-4S , Turnigy 2217 16turn 1050kv 23A Outrunner, ZIPPY Compact 1000mAh 3S 35C Lipo Pack battery and Fly sky 6ch. tx-rx.
The problem started when I tried throtle (offcourse w/o props), motor #4 starts too late, actually after 70% thorttle and cuts just below 50% throttle. I swapped motors to confirm motor+ESC at postion 4 are not malfunctioning. I also checked throttle range- its working normally if check withiout FCB.

What is the cause and solution of the problem?
drpiyush is online now Find More Posts by drpiyush
Reply With Quote