View Single Post
Old May 07, 2013, 09:31 AM
mrmurder1975 is offline
Find More Posts by mrmurder1975
Registered User
mrmurder1975's Avatar
Joined Dec 2007
733 Posts
thanks walkover. its slowly starting to sink in now. so,as per the diagram on page one,the numbers correspond to the legs around the chip. so i would have to solder the right wire from the asp to the right leg around the chip and once all done,i can flash the esc. thats going to be a hell of a solder job,those pins on the chip are tiny!!

how likely is it,as someone who evidently has more of a grasp on this than i, that the fet pin assignment is different in my esc to other redbrick 30a esc's that have a slightly different layout to mine? or is there really no way of knowing.

one more question. assuming i get to the point where i am ready to flash it,which firmware do i use? i will be using the kk2 flash tool to do my esc's. i can see fw for the rb 70 and 50a esc's,but none for the 30. is it safe to use the fw for the 50a on mine?
mrmurder1975 is offline Find More Posts by mrmurder1975
Last edited by mrmurder1975; May 07, 2013 at 09:38 AM.
Reply With Quote