View Single Post
Old May 07, 2013, 07:27 AM
WalkOver is offline
Find More Posts by WalkOver
Registered User
Joined Apr 2013
44 Posts
You just have to read the first page and look at the ATMEGA8 picture.
Your will see that the programming pins are :

MISO : 16
MOSI : 15
SCK : 17
RESET : 29
GND : 3,5,21
VCC : 4,6

Then, you can solder your USBasp directly on these pin or by the programming pad if you are able to determine their assignment.

To determine your FET pins assignment, use a multimeter or an ohmmeter and look into all the include files to see if it correspond to the red brick 30A or an other. If I doesn't, your can use your own assignment as Simonk said in his description.
WalkOver is offline Find More Posts by WalkOver
Reply With Quote