View Single Post
Old Aug 10, 2004, 09:51 AM
mcross is offline
Find More Posts by mcross
It's a spiderweb of knit lines
Souderton Pa. USA
Joined Mar 2002
2,679 Posts
Hi Rajesh,
I have been working with Philips motor control chips. So far I'm not to the point of interfacing with a rx, but will be soon. Can you tell me how you did the conversion from PWM(from the rx) to analog voltage(for the controller chip)? values of components and circuit layout would help, if you could.
Mine are a lot smaller, motor is 7mm diameter and weights 3 grams. Controller weights about 1 gram and is good for about 1 amp without heatsink. No thrust figures yet, I'm still working on finding the best winding.
Mike
mcross is offline Find More Posts by mcross
Reply With Quote