View Single Post
Old Apr 13, 2013, 03:46 PM
Dennis Frie is offline
Find More Posts by Dennis Frie
Just another user
Dennis Frie's Avatar
Denmark, Capital Region of Denmark, Naerum
Joined Feb 2011
1,368 Posts
Quote:
Originally Posted by Devonboy View Post
Finally got an MTK3329 GPS.
Configured at 9600 baud and 1Hz update.

Set the same in config.h and when the GPS is connected, it either won't fully boot or boots up and then reboots over and over.

I have another GPS that runs at 38400 baud and 1Hz update rate.
Same thing with this one (after changing config files and uploading).

It runs fine with nothing at all attached (although the battery counter counts up quite rapidly?).

Any clues as to what is going wrong here...

Nigel.
That sounds weird. I've never experienced that it have rebooted.

What hardware did you use for testing? An Arduino or the dedicated OSD-hardware? Arduino have some auto reset function associated with serial-communication
Dennis Frie is offline Find More Posts by Dennis Frie
Reply With Quote