View Single Post
Old Apr 13, 2013, 03:41 PM
Devonboy is offline
Find More Posts by Devonboy
Registered User
SW England
Joined Aug 2009
804 Posts
Finally got an MTK3329 GPS.
Configured at 9600 baud and 1Hz update.

Set the same in config.h and when the GPS is connected, it either won't fully boot or boots up and then reboots over and over.

I have another GPS that runs at 38400 baud and 1Hz update rate.
Same thing with this one (after changing config files and uploading).

It runs fine with nothing at all attached (although the battery counter counts up quite rapidly?).

Any clues as to what is going wrong here...

Nigel.
Devonboy is offline Find More Posts by Devonboy
Reply With Quote