View Single Post
Old Apr 03, 2013, 11:13 AM
Rejean Boucher is offline
Find More Posts by Rejean Boucher
Registered User
Rejean Boucher's Avatar
Joined Nov 2004
95 Posts
Quote:
Originally Posted by Henry. View Post
In the latest and last firmware V4.7 so was the update frequency from the board raised to 290Hz.

But it all also have to do if the ESC and servo you using could handle that higher frequency.

http://www.rcgroups.com/forums/showp...5&postcount=73
Thks Henry for your response; I am aware of the output side of the board's frequency pulses to ESC being on the higher end. I currently fly my Tricopter with modified Blheli firmware on my Turnigy Plush 18 Amp Silabs speed controls. I am curious on the input side of our flight control boards were we connect our Elev, Aileron, rudder & throttle leads will the firmware/hardware accept a higher then normal 50 Hz pulse for lets say the aileron & elevator servo command but also at the same time accept a rudder input signal from the RX in the normal 50 Hz range?
Rejean Boucher is offline Find More Posts by Rejean Boucher
Last edited by Rejean Boucher; Apr 03, 2013 at 08:48 PM.
Reply With Quote