View Single Post
Old Mar 09, 2013, 12:03 AM
poziovahim is offline
Find More Posts by poziovahim
Registered User
poziovahim's Avatar
United States, NM, Espanola
Joined Nov 2011
555 Posts
Quote:
Originally Posted by Rem Fodder View Post
Its been a very long time since I did any covering on a model, but for you more experienced modelers out there, what would you suggest I should do to pull out the bubbles and wrinkles on this kit? Would a hair dryer be of sufficient heat to pull the wrikles and creases out, or am I going to have to get a covering iron. I took a quick pic of the fuselage which has more than its fair share of wrinkles. Thanks.

Rem
Eh Rem,
Mine was just as terrible as yours
I used a heat gun and a cotton sock! Wave the gun and follow your waves with a rub of the sock to smooth it down! You will need to seal down ALL seams with an iron of some sort tho! I pull my fingers against the seams on the edges to "feel" if they need the iron and I found that ALL the edge seams needed attention!
Dan
poziovahim is offline Find More Posts by poziovahim
Reply With Quote