View Single Post
Old Mar 08, 2013, 08:48 PM
epicdoom is offline
Find More Posts by epicdoom
Micro Crazy Man
epicdoom's Avatar
Baltimore, Md.
Joined May 2004
1,531 Posts
Again Thank you. Im a hard nosed Marine corp combat vet when I set to do something it gets done at any cost. I just find relaxing a bit more injoyable then learning these days. Once I do get started tho Ill see it through. It was easy building PCBs and little adapters for chips to fit my programer for the IR stuff. I do toner type resist PCB for some really tiny stuff I just layed out with a fine point sharpie and cut traces with an exacto knife through the clad. My thought is to build this deadbug style but also to sand or grind down the components to critical limits to keep weight as low as possible would like to get it down to 75mg but 100mg would be good for what I need it for. I like tiny planes mostly 1/72 scale 2.8g AUW but I want a sub gram flyer.gonna go hunt down some info get started.
epicdoom is offline Find More Posts by epicdoom
Reply With Quote