View Single Post
Old Feb 26, 2013, 09:09 AM
Jon Snow is offline
Find More Posts by Jon Snow
You know nothing....
Jon Snow's Avatar
Joined Sep 2011
3,622 Posts
I don't know if this idea is any good for your set up.I found apiece of alu tube which would just accept the two rods when slightly flattened,epoxy and crimped tight.At the single end I epoxied a carbon rod and crimped the tube either side.Heat shrink to tidy up.I've given it a few hard tugs,seems strong enough.
Jon Snow is offline Find More Posts by Jon Snow
Reply With Quote