Thread: New Product BLADE130x ????????
View Single Post
Old Feb 23, 2013, 10:55 AM
sideburn is offline
Find More Posts by sideburn
Registered User
sideburn's Avatar
USA, CA, Cardiff-by-the-Sea
Joined Nov 2005
1,998 Posts
Quote:
Originally Posted by garryk View Post
Take off the tail blades and see if you can move it while spooled up. Could be blade grip bearings.
Garry K.
Ok that was a good idea. I removed the main and tail blades and spooled it up in idle up 100% throttle. all servos were working at first. Then i twisted the heli back and forth in my hand to excersise the 3 axis gyro a bit and bam, no more rudder servo control. I did some more flipping the heli around in my hand and i lost the elevator servo control as well.. various cyclic servos were drifting in and out of letting me control them or not. The tail servo was dead the entire time.

Next I spun the tail servo gears by hand to see if they would kick in like the servo was stuck or something but nothing. I spooled all the way down and still no rudder servo control, then all the sudden the servo motor kicked back in and I could control it.

It must be the 3 in 1....?
sideburn is offline Find More Posts by sideburn
Reply With Quote