View Single Post
Old Feb 22, 2013, 09:43 PM
carrera mike is offline
Find More Posts by carrera mike
Aviation Maintenance Manager
carrera mike's Avatar
United States, VA, Chesapeake
Joined Dec 2012
313 Posts
Quote:
Originally Posted by earlwb View Post
I remember people just making them before. One way is to take a piece of aluminum and drill three holes in it for the pushrods. You can then either drill and tap holes for set screws, or even tap the holes and screw the pushrods into it, or both even.

The simplest method is ......
Thanks for this very good tip. Appreciate your time.
I was searching Towerhobbies for the piece with no luck. I swear its made by Dubro or Sullivan. Youre right its just an aliminum block with three set -allenscrews locking the pushrod wires in place.
carrera mike is offline Find More Posts by carrera mike
Reply With Quote