View Single Post
Old Feb 22, 2013, 05:46 PM
DJO is offline
Find More Posts by DJO
Trader Rating: 95
Custom FPV Setups
DJO's Avatar
United States
Joined Oct 2011
3,787 Posts
Trader Rating: 95
3DHS 41'' Edge RX-Ready - NOW SHIPPPING $150

Hey Everybody -

Up for sale is my 3D Hobby Shop 41'' Edge - in the orange color scheme. I built this plane a while ago but never really enjoyed flying it too much, IDK... but then I put in this new setup and it's a lot more fun, however, now I'm looking to fund something else.

I need to get this sold!


3DHS 41'' Edge (Orange)
Turnigy Park 480 Motor 1020kv
FLiPower 40A ESC w/BEC
Turnigy MG Servos x 3
Parkzone SV80 x 1
1800 mAH 3S 25C Zippy Compact - get about 5-7 minute flight times
Genuine Deans Connectors
12x6 APC Prop
Prop Adapter - NO SPINNER

It's not in PERFECT condition, but it's not in BAD condition either. A few wrinkles on the side, easily fixed with a heat gun or whatever if you'd like, but it flies fine with them anyways, as well as a couple of nicks and such on the bottom of the fuselage. The cowl has a couple of quarters in it (like 2 or 3) to balance this plane out perfectly. The balsa piece that goes across the fuselage broke off, and the magnets are gone also, but they aren't needed because there's a little latch like thing that the canopy goes into. I've had no issues with it yet. Oh yeah and the wheel pants and such are also gone, they got beat up from grass landings. I put some tape over the chrome type landing gear so that the black matches the plane's scheme The motor box and some parts of the fuselage were recently repaired but nothing extensive or major. There are a few other miscellaneous balsa cracks throughout the plane. Some of the plastic came off of the side of the SV80 servo so I put a piece of tape over it so that no small rocks or anything could get in it. Operates fine. Two servo holes in the tail were covered up with black tape. I mixed up the elevator/aileron servo holes/linkages so I had to swap them.

Flies fine. It's not like a hardcore, 3D machine but it can do the loops and rolls that you need it to. I mainly flew it for sport flying. It is not set up for crazy 3D. Has Deans connectors on the ESC and battery - originals, not fake. Makes a great first 3D balsa plane. It was my first balsa plane overall.

$150 + shipping. Shipping is going to be expensive, but it depends where the package needs to go. This is sold AS IS. No returns or refunds, sorry. The rudder linkage will be unhooked for shipping. All you have to do is put it back in the servo connector and tighten the set screw. The airframe itself costs about $130 when you add in shipping, and that's just the airframe. So you can get a lot more at this price!

....Local pickup is preferred as well if possible....

It'll probably be about $175 to $190 shipped, I'd guess.

Thanks! PayPal only, continental USA only.

DJO is offline Find More Posts by DJO
Last edited by DJO; Feb 25, 2013 at 07:45 PM.
Reply With Quote