View Single Post
Old Feb 22, 2013, 04:23 PM
ZAGNUT is offline
Find More Posts by ZAGNUT
supreme being of leisure
ZAGNUT's Avatar
Tel Aviv, Israel
Joined Jul 2004
3,167 Posts
Quote:
Originally Posted by Machzx View Post
That is neat
New one to me
I have welded outer bearing races like you describe just the race stuck and hard to get out
You weld around where the bearing runs inside and when it cools the race falls out
You could do that on a model engine too
Tig would be best there
Not everyone has access to that
But it is really painless way
Just me sharing
yep, no quicker way to add an extreme amount of heat very quickly without doing damage to other parts....same shrink method can be used to "restore" cox cylinders but with a torch instead of welding. cherry red then air cool and you're ready to hone....do just the top of the cylinder and you can even get some taper.
ZAGNUT is offline Find More Posts by ZAGNUT
Reply With Quote