View Single Post
Old Feb 21, 2013, 07:35 PM
ZAGNUT is offline
Find More Posts by ZAGNUT
supreme being of leisure
ZAGNUT's Avatar
Tel Aviv, Israel
Joined Jul 2004
3,167 Posts
had a .28FSR (think that was it) that would not let go of its rear bearing with a reasonable amount of heat. so out came the dremel with a carbide burr, first to take the cage apart and then to cut through the outer race. only took a minute or so. left a few marks on the bearing seat but not enough to hurt anything. new bearing went right in with no problems after heat soaking the case and freezing the bearing.
ZAGNUT is offline Find More Posts by ZAGNUT
Reply With Quote