Thread: Build Log Flyguy 62 Version 2
View Single Post
Old Feb 21, 2013, 04:08 PM
Otto Dieffenbach is offline
Find More Posts by Otto Dieffenbach
United States, CA, San Diego
Joined Aug 2011
2,885 Posts
Step 2

If you cut the parts yourself or order cutouts from flyingguys.com the second step will be to create the laminated parts. These have been added to Version 2 to make Flyguy 62 rugged. The laminations are 3mm Depron sandwiched between two pieces of 1/16" plywood. I used Gorilla Glue to laminate and used plastic bags to protect the table top and heavy weights while the glue sets. Once dry, sand and trim for assembly. You will have two front body sides, the lower head and the motor support cross member.
Otto Dieffenbach is offline Find More Posts by Otto Dieffenbach
Last edited by Otto Dieffenbach; Feb 21, 2013 at 07:08 PM.
Reply With Quote