View Single Post
Old Feb 18, 2013, 07:18 AM
anlucas is offline
Find More Posts by anlucas
Registered User
anlucas's Avatar
Greece, Attica, Athens
Joined May 2011
3,977 Posts
These new version, more sensitive balancer models are proving to be difficult to use for larger (90mm) fans and heavier 70mm fans.

I am achieving good balance to around 95%+ but a point comes where, even with the sensitive dial set to the minimum, I can't get the balancer to highlight just 1 consistent spot. Usually I get the mark appearing over 1/4-1/2 of the spinner. I had to try different spots by trial and error to improve the balance after that.

Any ideas on which softer tube material could I use to reduce the sensitivity?
anlucas is offline Find More Posts by anlucas
Reply With Quote