View Single Post
Old Feb 15, 2013, 03:25 PM
joesmith285 is offline
Find More Posts by joesmith285
Redwing FTW
joesmith285's Avatar
United States, IN, Fort Wayne
Joined Nov 2008
1,440 Posts
Quote:
Originally Posted by alfabeast View Post
Have experienced the same on some, not all of the ztw's. Before you take off, just trim throttle up so the prop barely spins. I had a 110 amp where the endpoints drifted while flying, so you would go low throttle and the the prop stopped. Have a 60 and 120 that are fine, no issues. I do have a steeper throttle curve dialed in my futaba 8fg. The Castle ICE 100's I run are a little smoother and run cooler.
It's probably not that the endpoints drifted, it's just that the battery voltage drops which affects the idle setting. If you had the motor constantly spinning before takeoff and then it's stopped when you land, if you wait for a little bit it will probably start spinning again as the voltage level rises. Castle's do the same thing.
joesmith285 is offline Find More Posts by joesmith285
RCG Plus Member
Reply With Quote