Thread: Discussion micro HLG - video at last!
View Single Post
Old Feb 15, 2013, 09:13 AM
mattconn24 is offline
Find More Posts by mattconn24
Registered User
mattconn24's Avatar
United States, TN, Murfreesboro
Joined Dec 2008
91 Posts
Quote:
Originally Posted by kajiyama View Post
I am using BSD form wing ;
http://www.bsdmicrorc.com/index.php?productID=698
This section is very good for micro SAL.
And the built up figure is as attached pics.
AUW 39.0g, wing Span: 600mm, total length:620mm,
Using HK 1.7g servo x2, Lipo: 1cell 100mAh
Receiver: HK DSM2 orange 4ch
Wing covering film : E-Light film from OK models ( thickness:20 micro)
The wing has no special reinforcement other than the covering film.
Only joint area and SAL peg area using micro glass cloth for strengthen.

Hope above information make sense to you.
Thanks
Yasuo
Could you share your method for fiberglassing the wing joints and tip for launching ped? This will be my first time using fiberglass and I do not know how. What thickness of fiberglass do I use? What glue?
mattconn24 is offline Find More Posts by mattconn24
Reply With Quote