Originally Posted by MrMel
EOS firmware 5.86 is now released
It's a service firmware with two fixes
- Termination of storage charge at low charge rate (less than 1C) now works properly.
- When using EOS suite there is no overlap in commands that cause delay, if you uses temporary fix before of raising command delay you can now lower it back to 40-80 or so.
Note: IR reading is lower than 5.52 and earlier firmware, this is on purpose to be aligned a bit more with the rest of the chargers on the market.
Firmware is found on http://media.hyperion.hk/dn/pc/eosfw586.html
I don't necessarily want the IR to be more in line with the rest of the chargers on the market. What I do want is for the measured IR to be as close as possible to reality.
What I also want is the IR to be calculated and displayed while storage charging. In firmware 5.82 the IR is always zero while storage charging. Is this remedied in 5.86? Thanks.